Installation
The MS44 is available in 2 versions.
MS44 I-VMS - WIRED
For wiring to the boats power supply
MS44 I-VMS - RECHARGE
For boats without onboard power. Recharge at home
WIRED
RECHARGE
Location
Ideally this is inside the wheelhouse near the window, but can be under the roof, in battery locker, inside console or cuddy.
- Reliable GPS fix
- Good mobile phone reception
- Status lights are easily visible
- Safe from damage
- Shielded from the rain or sea water
- Away from standing water
The I-VMS is IP67, but a protected mounting location will improve operational life and prevent accidental damage
MS44 I-VMS - Wired
The I-VMS should be wired in after the battery isolator so that it is not powered when the boat power is off.
- Mount stainless steel bracket to boat
- Connect I-VMS to power supply
- Fix I-VMS with tamper seal and cable tie
- Ensure powered when fishing
MS44 I-VMS - RECHARGE
- Mount bracket to boat
- Charge I-VMS
- Attached I-VMS to bracket when fishing

Proud to Support the Shipwrecked Mariners’ Society
A donation to this important charity will be made for every I-VMS installation .